Sun-microsystems Ethernet MMF/UTP Adapter Instrukcja Użytkownika Strona 53

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 122
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 52
Chapter 2 Installing the Adapter 19
3. Press the Attention button.
The power LED should blink about 10 times then remain a steady green light.
To Verify the ExpressModule Installation
1. Use the cfgadm command to verify the ExpressModule installation:
If the ExpressModule is properly installed and connected, you should see output
similar to the following:
2. Use the dladm show-dev command to verify that the link is up.
You should see output similar to the following:
# cfgadm
Ap_Id Type Receptacle Occupant Condition
pcie5 etherne/hp connected configured ok
# dladm show-dev
e1000g2 link: up speed: 1000 Mbps duplex: full
e1000g3 link: up speed: 1000 Mbps duplex: full
Przeglądanie stron 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 121 122

Komentarze do niniejszej Instrukcji

Brak uwag