Sun-microsystems SUN STOREDGETM 5310 NAS Instrukcja Użytkownika Pobierz pdf (Strona 135)

Chapter 2 NAS Head 2-89

NDMP backup fails: access denied message.

NDMP software must authenticate to the StorEdge in order to backup files and

directories. Each NDMP software solution has a place to configure a username and

password for a device. For StorEdge, the username is “administrator”, and should be

accompanied by the console password.

NDMP: Can’t browse backup history.

Certain NDMP backup utilities are not able to browse backup history without a

configuration change on the StorEdge. To make this configuration change, it is

necessary to access the StorEdge CLI.

This behavior is configurable only at the Command Line Interface (CLI).

1. To access the StorEdge CLI, connect to the StorEdge via Telnet, and type “admin”

at the [menu] prompt and enter the administrator password.

2. At the CLI, enter “ndmp set dump.pathnode=yes”.

3. Then “ndmp set tar.pathnode=yes”.

4. Then “ndmp save”.

NDMP incremental/differential backups back up all files.

Some Windows applications, such as virus scanning software, update timestamps on

all files that they scan. NDMP software uses this same timestamp to identify

whether the file has been backed up since the last full backup. As a result, NDMP

sees all these files as modified, and effectively performs a full backup instead of the

desired incremental or differential.

To avoid this problem, it is possible to configure StorEdge to ignore this timestamp

when performing NDMP backup.

To access the StorEdge CLI, connect to the StorEdge via Telnet, and type “admin” at

the [menu] prompt and enter the administrator password.

From the command line enter:

ndmp set ignore.ctime=yes

ndmp save

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 381 382

Brak uwag

Sun-microsystems SUN STOREDGETM 5310 NAS Instrukcja Użytkownika Strona 135